Cut & Sewn Nitrile Gloves
Light palm coated cut and sewn nitrile dipped gloves. A comfortable glove with excellent dexterity, enhanced grip particularly useful in slippery and oily environments.
Nitrile coated palm and finger on white cotton shell.
Construction gives you excellent hand dexterity.
Enhanced grip particularly useful in slippery and oily environments.
Knitted wrist for enhanced grip.
Blue coloured nitrile coated on palm and finger.
Lite dipped .
Knitted wrist for better grip.
PRODUCT MAKE :
Yarn Count: 40 S
Fabric/Material : Cotton
Piping : None
GSM/Gauge : 165 Gauge
Liner : 100% Cotton
SIZE: Universal 6 7 8 9 10 11
INDUSTRY / JOB: Oil, Gas & Petrochemical, Logistics & Transportation, Chemical & Paint, Material Handling, Forestry & Horticulture, Agriculture, Consumer Goods (FMCG)
HAZARD / RISK: Dust, Puncture, Abrasion, Dirt, Heat, Oil
PRODUCT WEIGHT: 775 gms per dozen pair
( Weight of product may vary depending on customisations )
MINIMUM ORDER QUANTITY :
Custom : 1000 Per Dozen Pair
Ready Made : 120 Pairs
HOW TO USE
Never leave to dry close to or on top of a heat source.
Not advised to use beyond 6 months of usage.
Not advised to be used for more than 6 hours at a stretch.
Can be used to handle oil and non-hazardous chemicals.
Not advisable for the risk associated with moving machine parts.
Advised to wash in cold water with mild detergent and can be tumble dried at low or no heat.
Advised to store in a cool, dry place, away from frost.
Abrasion as per EN 388 is 4: Resistance to abrasion based on the number of cycles required to abrade through the sample glove (abrasion by sandpaper under a stipulated pressure). The protection factor is then indicated on a scale from 1 to 4 depending on how many revolutions are required to make a hole in the material. The higher the number, the better the glove.
Cut as per EN 388 is 1: Blade cut resistance based on the number of cycles required to cut through the sample at a constant speed. The protection factor is then indicated on a scale from 1 to 5.
Tear as per EN 388 is 1: Tear resistances based on the amount of force required to tear the sample. The protection factor is then indicated on a scale from 1 to 4.
Puncture as per EN 388 is 1: Puncture resistances based on the amount of force required to pierce the sample with a standardly sized point. The protection factor is then indicated on a scale from 1 to 4.
TDM blade cut resistant as per EN 388 is X (X means not tested): The glove sample is placed on a conductive strip and loaded onto the TDM-100. When the metal blade touches the metal strip, the test is terminated. A straight blade is loaded into the machine. Weight is added to serve as a force. The blade moves across the fabric. The blade is replaced with a new one to ensure accuracy. The sample is cut five times, each with three different loads. The distance travelled to cause cut through at various forces is recorded. The data is used to determine the load required to cut through the sample.
Nitrile provides usefulness in an oily and slippery environment.
These gloves can be used effectively to resist chemical and abrasion hazard.
Lightweight gloves ensure comfort.